STANLEY FATMAX 1-92-980 Folding Metal Sawhorse, 1135 kg, 2 Pack

STANLEY FATMAX 1-92-980 Folding Metal Sawhorse, 1135 kg

The STANLEY FATMAX 1-92-980 is a folding metal sawhorse with telescopic, height-adjustable legs. The manufacturer publishes the article as a pack of two (Piece Count 2) and states a load capacity of up to 1135 kg when used as a pair.

Independently adjustable legs

Each leg extends and locks on its own. That matters on uneven ground - on site, on a staircase or over loose terrain - where an ordinary sawhorse sits crooked and throws the workpiece off. Working height is levelled in seconds, with no packing pieces.

Folding and transport

The sawhorse folds in seconds to 69 x 11 x 83.1 cm closed and takes up very little room in a boot or in the corner of a workshop. Opened, it measures 690 mm wide and 395 mm deep. Manufacturer's stated weight is 12.3 kg.

Holding and stability

The top carries a lengthwise groove that stops beams, battens and pipes rolling while being cut. Lower down the legs there is a shelf for tools and small parts, and anti-slip rubber feet keep the sawhorse where it is put on a smooth floor.

Applications

Two of these make a makeshift bench for cutting timber, cladding, plasterboard and panels. They also serve as a support when fitting doors and window frames, when painting boards, and for staging material temporarily on site.

Where it sits against plastic sawhorses

The difference from lighter plastic sawhorses is in the legs: here they are metal and telescopic, which raises both the load rating and the ability to level up. That makes the 1-92-980 the heavier, dearer option in the range - bought when the work is regular, on site and over uneven ground, rather than occasional on a flat workshop floor.

Note on pack contents

STANLEY publishes article 1-92-980 as a set of two sawhorses, and the stated 1135 kg capacity applies to the two used together.

Technical specifications

Questions and Answers