Guide Rail Adapter - Milwaukee, for Cordless Router, 4932493306

Milwaukee Guide Rail Adapter, 4932493306

Milwaukee 4932493306 is an adapter connecting a router to a guide rail. It consists of a metal base that runs on the rail, two guide rods and two knobs for tool-free clamping.

What it solves

Freehand, a router follows the edge of the workpiece or a template. On a rail it follows a straight line set by the rail itself, whatever the edge happens to be. That is why the adapter is essential for long grooves, rebates and slots in the middle of a panel, where there is nothing to run against.

The two rods

The rods enter the router base and clamp. Two rather than one, because a single rod lets the machine pivot around it and the cutter wander off the line. With two the angle is fixed and the cut stays parallel to the rail along its whole length.

Tool-free clamping

Both screws have large hand knobs. Setting the distance to the rail is done repeatedly until the cut lands exactly right - with a spanner that would take several times longer and would almost certainly end in working by eye.

Check the rail and the machine

Rail adapters are not universal: the shoe is profiled for one rail system and the rods are sized for one router base. Before ordering, check article 4932493306 against both your machine and the rail you use.

Set up before cutting

Make the first cut on an offcut. The distance from the rail edge to the cutter axis depends on cutter diameter, and cutters get changed - so the setting does not carry over between jobs. Once found, write it down rather than remember it.

Maintenance

Keep the rods clean and lightly oiled. Wood dust on them makes the travel jerky, and jerky travel shows in the cut as ripples. Oil thinly - a heavy film collects dust and makes matters worse.

Technical specifications

Questions and Answers